•
Using the PLUS button, it is possible to select a higher power level, in this case the automatic
heating time will be adapted to the selected setting.
•
When the heating time has ended, the previously selected power level will appear on the
display.
The afterheat indicator
This warns the user that the ceramic glass is at a dangerous temperature if there should be contact
with the entire area above the cooking zone. The temperature is established by following a
mathematical model and if there is any afterheat, “H” appears on the corresponding display with
seven sections.
Heating and cooling are calculated according to:
•
The selected power level (from “0” to “9”)
•
The relay activation time.
After switching off the cooking zone, “H” appears on the corresponding display until the cooking
zone temperature drops below the critical level.
The automatic switch off function (Operating time limit)
According to the power level, each cooking zone is switched off after a pre-established maximum
time, if no operations are carried out.
Each operation on the cooking zone (using the PLUS and MINUS buttons or the double circuit of
the zone, if present) restores the maximum operating time for the cooking zone to its initial value.
•
When the control is activated, the ON/OFF button has priority over all other buttons, therefore
the control can be switched off at any moment even if for multiple or continuous activation of
buttons.
•
On stand-by mode, continuous activation of buttons will have no effect, however, before the
electronic control can be switched on again, it needs to recognise that no button has been
activated.
7
Summary of Contents for MKL 5460
