122
Fiber Optics
FRDA/FRRA Series RF Attenuation Requirements
The RF output level from the optical receiver module varies consider-
ably over its operational optical input range. It is also dependent upon
the transmitter’s channel loading, its resultant RF input level and the
FRRA/FRDA RF output capability. In order not to overload the ampli-
fier section input, an internal attenuator must be installed. To find the
recommended attenuator value, first determine the receivers opti-
cal input level as noted in the "Input Optical Power”. Refer to the
Configuration Table below, locate the power monitor voltage or
input dBm in the left hand columns. Read across on the corre-
sponding row to find the value required.
G
R
E
E
N
L
E
D
Model
FRRA-S4A-860P
CH. Loading
110 CH.
Output Level
34/42
Optical Input
dBm mW
-10
0.10
-9
0.13
-8
0.16
-7
0.20
-6
0.25
0 dB
-5
0.32
2 dB
-4
0.40
4 dB
-3
0.50
6 dB
-2
0.63
8 dB
-1
0.79
10 dB
0
1.00
12 dB
1
1.26
14 dB
2
1.58
16 dB
3
2.00
18 dB
4
2.51
5
3.16
Increase Optical Input Power
Orange Optical LED Indication
Decrease Optical Input Power
Red Optical LED Indication
Recommended
Attenuator
Value
Summary of Contents for AMM-806
