29
Boot-Up Display Sequence
When the unit is first plugged in for use, the PCM displays the appro-
priate module condition on the LCD readout as depicted below.
1. Each control module has a unique module address that is set at
the factory which is displayed immediately following the primary
or secondary power source status. This address is used for remote
software capability only using AQT-RCS (Stock # 2736).
2. Each module status is identified and reported on the LCD. If a
module is identified it is listed as "PRESENT" or "NOT PRESENT"
if not connected or identified by the PCM.
3. The AQT "NOT PRESENT" message will be displayed when the
optional Remote Configuration Server (RCS) Module is installed
in a particular chassis slot.
4. Upon completion of the boot-up sequence the AQT-PCM is
ready for use and will proceed to the loop display sequence.
5. DO NOT push any switches on the control module during this
sequence, as it will NOT respond until it displays "AQT-PCM
IS READY".
AQT - ATSC to QAM Transcoder
AQT - Boot-Up Display Sequence
Operating Interface Instructions
Summary of Contents for AMM-806
