36
AQT Quick Set-Up Instruction Guide
The Quick Set-Up instructions are provided as a checklist of the
minimum steps required to install and program the AQT.
1. Verify all cable connections
a. Check to make sure the power/data cables are connected to
the correct location on the PCM and the respective modules to
ensure proper communication
b. Check to make sure the correct RF cable is connected to the
Input and Output F connector
2. Verify RF input levels
a. Signal acquisition range is -20 to +20 dBmV — -10 to +10
dBmV is the desired optimum level
3. Program the desired Input Frequency for each appropriate
module —
Tuning Range 54-864 MHz
4. Program the desired Output Channel for each appropriate
module —
Tuning Range CATV 2-135
a. +40 dBmV is recommended for optimum level for SNR
performance
5. Verify the Module Lock state —
Press the
u
(R) arrow key until
the SNR value is shown for the appropriate module
a. If not locked, activate the Input Browse mode for the module,
this will auto search & tune all pre-programmed modes
b. Verify input signal level, feed/cable
NOTE:
Repeat as appropriate for each module
AQT - ATSC to QAM Transcoder
Summary of Contents for AMM-806
