2 Clearview NTSC16
Quick Guide
Product Introduction
The
Clearview NTSC16
is a cutting-edge 1RU, multi-channel digital to RF analog synthesizer, designed to convert up to 16 HD
or SD programs and the primary audio channel to 16 NTSC modulated RF analog channels.
The
Clearview NTSC16
can input MPEG-2, MPEG-4/H.264 (AVC), or H.265 (HEVC) formats from an IP transport stream. Each
IP MPEG transport stream is decoded, NTSC synthesized, and modulated to an STD, IRC, or HRC RF analog channel. All 16
NTSC channels are agile within a 208 MHz frequency block. Users may place the 208 MHz block anywhere within the 54 to
1002 MHz frequency span.
Features:
•
Creates a 16 NTSC RF analog modulated channel lineup
•
Decodes MPEG-2, H.264, and H.265 video content
•
Dolby® Digital AC3, AAC, MPEG1-Layer2, MP3 audio decode
•
Line 21 Closed Caption EIA 608 pass through
•
Supports AFD or Manual aspect ratio configuration, 4:3 or 16:9
Before You Begin
Unpacking the Unit
You will find the following items in the box:
•
Clearview NTSC16
Decoder (QTY=1)
•
Power Cord with IEC C13 line socket and 3-pin Type B NEMA 5 plug (QTY=1)
The
Clearview NTSC16
is designed to be installed in a standard 19-inch (483 mm) rack (EIA 310-D, IEC 60297, and DIN 41494
SC48D).
To install, secure the unit's front panel to the rack by inserting four (4) machine screws, with cup washers, through the
four (4) mounting holes in the front panel. A 1RU open space is recommended above the unit for ventilation.
Step 1: Setup and Install of the Unit
To power the unit up, connect the IEC line cord to the receptacle on the rear panel. Then connect the other end to a
120 VAC power outlet. The input power receptacle is equipped with a fuse-holder and fuse (SLO-BLO, 3.0 Amp, 250V).
DO NOT BLOCK THE UNIT'S AIR INTAKE OR AIR DISCHARGE OPENINGS
The Unit performance will be degrated without proper ventilation.
Excessive heat will shorten the life of the unit.
WARNING
For safe and reliable operation, the ground pin of the power cord must be grounded properly.
1
2
