5
Clearview NTSC16
Quick Guide
Step 4: Basic Configuration (continued)
REMINDER
If the IP Address is changed, the procedure in Step 3
must be repeated using the new IP address in place
of the default IP address in order to re-access the control panel.
IMPORTANT
A reboot is required after applying a configuration file.
The user is also able to reboot the unit and upload/download configuration files. Once downloaded, the settings can be
applied to the unit or the user can choose to set the unit back to the default factory settings with a click of a button.
System Settings
Go to the “
System
” tab to change the System Settings, including unit identification and network settings.
System Page - Full View
The following Ethernet Settings can be changed: IP address, Subnet Mask, Default Gateway, and the Primary and Secondary
DNS. In addition, the network settings for each decoder slave are individually configurable. Click “
Apply Settings
” in order
to save new or changed settings.
This section allows the user to individually configure the network settings for each numbered decoder (DC1:1 to DC1:8 and
DC2:1 to DC2:8).
Decoder Ethernet Settings
