23
FlexCoder
Instruction Manual
4.11 “Event Log” Screen
The “Event Log” screen (Figure 4.11) is a “read and write” screen where the following parameters can be displayed or
configured. The data in Event Log can be forwarded to a Syslog database.
The lines are color coded as follows:
Red font = error message
Blue font = informational message
Green font = confirmation or feedback message
Event Log Destination:
is the IP address of the remote server, to which Syslog sends the activities recorded by the
unit for monitoring and troubleshooting purposes. (Factory Default: 172.16.70.2)
Log Destination Port:
is the Event Log Destination port to which a duplicate of the error messages created by the
unit can be forwarded for monitoring and troubleshooting purposes. (Factory Default: 514, cannot be changed)
Clear Log:
allows the user to clear the records generated during unit’s boot-up process and operation afterward.
Lines to Display:
allows the user to select the number of lines to be displayed. The unit supports up to 400 Mb of
data or approximately 65,000 lines. The range is 1 to 65,535. The records are maintained if the unit loses power.
Save Number of Displayed Lines:
allows the user to save the “Lines to Display” setting. Please note that the event
log would be saved only on the screen and not on any database.
1
2
3
4
5
Figure 4.11 - “Event Log” Screen
1
3
5
2
4
