12
eng
1
-
17
Crib Set Up
– (#09 side panels, #04 side stays, #01 tool -
hex key, #06 bolts) assemble the 4 side stays
onto the upper level of the side panels by
tightening the bolt using the tool included (hex
key). (refer to illustration 1 & 2)
– (#03 end stays, #08 end panel, #01 tool - hex
key, #06 bolts) Assemble the 2 end stays to
the upper level on both end panels. Make
sure stays are correct side up.
– (#08 end panel, #09 side panels, #01 tool –
hex key, #06 bolts) Join two side panels to
one of the end panel by tightening the bolts
with tool included (hex key). Make sure the
sides with stays assembled faces to the inside
of the crib. (refer to illustration 3)
– Assemble the other end panel by tightening
the bolts with tool included (hex key). (refer to
illustration 4)
– (#01 tool – hex key, #05 long bolts) Tightening
the end panels’ posts using the long
bolts with tool included (hex key). (refer to
illustration 5)
– Fully extend the crib frame by pulling end
panels outward.
– (#02 base board) Place the base board within
the crib frame, onto the stays. Make sure
correct side up – the side with labels is the
top side of base board. There are dowel pins
on the base board stays which will align with
the holes in the base board to allow correct
placement.
– Lock the clasps on both ends of the base
board, check the clasps are firmly locked and
the base board should be both secure and
perfectly flat.
– Assemble the bed base onto end stays on
both end panels by tightening the bolts with
tool included (hex key).
– (#03 end stays, #04 side stays, #01 tool – hex
key, #06 blots) To change base board level -
remove all 6 base board stays from the frame
(side stays x 4 + end stays x 2) by loosening
the bolts using the tool included (#01 hex key).
– Assemble the 6 base board stays to your
desired base board level. Secure by tightening
the bolts with tool included (hex key). Make
sure the stays are assembled correct side up.
(refer to illustration 15)
– Please store the tool (hex key) in safe place for
future use.
– The crib assembly is now complete.
18
-
19
Castors Assembly
– 4 lockable castors are included. The use of
these is optional.
– If you choose to use castors with your
crib, always lock the brakes of the castors
whenever the crib is in use.
– (#09 castors, #10 washers) Slide the washer
onto the screw of the castor. Then attach the
castors by screwing them into the threaded
holes by turning the hex bolt until tight.
– To lock castors, push down on the locking
lever on each castor.
– To unlock, lift up the lever on each castor.
– To remove castors, turn hex bolt to unscrew
loose.
Mattress
– Mattress is not included with the crib. This
can be purchased separately. Always use a
mattress with your crib.
Summary of Contents for alma mini
