14
eng
battery compartment. (refer to illustration 19)
– Attach battery cover by fastening the screws.
To operate vibration unit
– Locate the switch button is on the side of the
vibration unit. (refer to illustration 20)
– Slide the button to ‘l’ for low or to ‘ll’ for
moderate vibrating frequency.
– Slide button to center ‘O’ to turn off vibration
unit.
To use and adjust safety harness
– To lock harness, push the tongues on ends
of waist straps, connected with the ends of
shoulder straps, into the buckle on crotch
strap. (refer to illustration 21)
– To unlock harness, press the central button.
NOTE:
Every time you place your child in the
lounger or whenever you alter the position
of the seat, always check that the harness
is correctly fitted. Tighten harness until it fits
snugly around your child.
To fold
– Press the button on both sides of seat frame
simultaneously and slide buttons forward
to disengage locking mechanism, then lift
upwards to remove seat frame from base.
(refer to illustration 22)
– Press the button on the base of each support
arm, while rotate the support arm inwards.
(refer to illustration 23)
– Place seat frame on top of base in the same
relative orientations as how coco go is used.
Stow away in carry bag. (refer to illustration
24)
Care and Maintenance
Removing seat pad, safety harness and plastic
board
1. On the back of seat frame, on either side of
vibration unit, unzip the two zippers around
frame. (refer to illustration 25)
2. Unhook the metal rings of the five straps from
the fabric loop of corresponding anchor strap.
(refer to illustration 26)
3. To remove the shoulder, waist and crotch
straps from seat pad, pull the straps through
the seat slits until they are free of the seat
pad. (refer to illustration 27)
4. From the opening at rear bottom of the seat
pad, remove the plastic board. (refer to
illustration 28)
5. The seat pad can now be cleaned following
the instruction on care label of seat pad.
Note:
• Before cleaning your seat pad, please take out
the plastic board from the seat pad.
• When cleaning your lounger, use a non-toxic,
nonabrasive cleaner. Mix a solution of water
with a small amount of a mild, non-toxic
detergent. Apply to frame surface with a
damp cloth. Never use strong detergents or
solvents for cleaning.
• Keep the lounger away from heat sources.
• If you need to put your lounger in storage
for any period of time do not store them in
a damp or hot environment. Allow air flow
around the lounger and do not stack anything
on it.
Summary of Contents for Coco Go
