To use a blu flavor cartridge, complete the following steps:
1. Remove one flavor cartridge from the pack.
2. Remove the plastic end cap from one end of the flavor
cartridge.
3. Remove the intake seal from the other end.
4. Screw the cartridge onto the battery.
blu cartridges are sealed until the cap and seal are removed, but
if for some reason you get fluid from the cartridge on your skin,
wash the affected area under water. Once a cartridge is empty, it
will not produce vapor and can be replaced.
5. Using the blu Electronic Cigarette
NOTE: The following instructions detail the only way the
blu electronic cigarette is to be used.
Once you have charged the battery and connected it to the
cartridge, you are ready to start using your blu e-cigarette.
Simply place the cartridge end in your mouth and inhale slowly
and deeply. This will vaporize the liquid, allowing you to inhale
and exhale vapor.
Each time you take a puff, the blue LED at the tip of the e-cigarette
will glow to indicate
the device is working
properly. When the
blue LED at the tip of
the e-cigarette flashes
approximately 30 times,
the e-cigarette battery
needs to be recharged.
The blu electronic
cigarette’s blue LED will
flash 15 times if you take a single puff lasting 8 seconds or more.
The e-cigarette will then temporarily stop functioning, but it will
reset after a few seconds. This shut-off feature helps ensure the
e-cigarette stays within normal operating temperature and usage
ranges, and helps provide a consistent quality experience.
Flavor Cartridge
Battery
