Manual
Roboost Roof Tiles Landscape
•
•
This manual is a general guide (and is therefore not specific to one project) for the straightforward and
efficient installation of solar panels using the Blubase mounting system. No rights may be derived from
this manual.
•
•
For the installation of the Blubase roboost mounting system the buildings should have a height of
max. 12 metres. If the building is taller, please contact Blubase in advance for a project-specific,
customised solution.
•
•
Installing solar panels on an existing building will change its structural load and/or construction.
We therefore recommend that the structural calculations for an existing building are updated by a
specialist, taking into account the solar panels to be placed and current regulations such as NEN6702,
NEN7250, NEN1991-1-4+A1+C2:2011/NB:2011 and NPR 6708:2013 in particular for wind, snow and
water loads.
•
•
The building insurer must be contacted in advance.
•
•
The following building-related elements should be checked and approved in view of the existing
structural arrangements:
•
•
The additional weight load of the entire PV system that will be installed
•
•
Geometry change of the roof surface
•
•
Wind pressure, snow load and water load, with simulation of accumulations
•
•
The loads for the structure, roof coverings and insulation during the installation
•
•
The suitability of the roof covering and insulation (point pressure) at the contact points between
the mounting system and the existing construction
•
•
The consequences of the thermal interaction between the building and the PV system
•
•
The consequences of any vibrations of the building and/or PV system
BLUBASE
IMPORTANT
DISCLAIMER
6
Blubase
|
Lingenstraat 9
|
8028 PM Zwolle, Nederland
|
T. (+31) 085-8000 501
|
info@blubase.nl
|
www.blubase.com
