340001-026 3/16
CJW Series
Convertible Well Jet Pump Water Systems
OPERATING INSTRUCTIONS & PARTS MANUAL
For parts, product & service information visit
www.blueangelpumps.com
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
© 2016, Blue Angel Pumps, Harrison, Ohio.
DESCRIPTION
Jet pumps are single stage domestic water pumps designed for pumping
potable water in applications where the water is up to 100 feet below
pump center line. A pressure switch is a standard feature. A built-in control
valve is available on deep well pumps. Deep well pumps can be mounted
to either a pre-charged, conventional type, or free standing pressure tank.
UNPACKING
After unpacking the jet pump, carefully inspect for any damage that may
have occurred during transit. Check for loose, missing or damaged parts.
SAFETY GUIDELINES
To help recognize this information, observe the following signal words/
hazard classifications.
Danger indicates an imminently hazardous
situation which, if not avoided, WILL result in
death or serious injury.
Warning indicates a potentially hazardous
situation which, if not avoided, COULD result in
death or serious injury.
Caution indicates a potentially hazardous
situation which, if not avoided, MAY result in
minor or moderate injury.
Notice indicates important information, that if
not followed, may cause damage to equipment.
This is the safety alert symbol. It is used to alert you to potential
bodily injury hazards. Obey all safety messages that follow this
symbol to avoid possible harm.
NOTE: Information that requires special attention.
GENERAL SAFETY INFORMATION
CALIFORNIA PROPOSITION 65
This product or its power cord contains
chemicals, including lead, known to the State of
California to cause cancer and birth defects or other reproductive harm.
Wear gloves when handling this product, and wash hands after handling.
GENERAL SAFETY
1. Read all manuals included with this product carefully. Be
thoroughly familiar with the controls and the proper use
of the equipment.
2. Know the pump application, limitations and potential
hazards.
Always install a pressure relief valve to
match the system pressure rating and the
maximum flow rate.
Do not use to pump flammable or
explosive fluids such as gasoline,
fuel oil, kerosene, etc. Do not use in explosive atmospheres.
Pump should be used to pump ONLY clear water. Failure to
follow this warning will result in death or serious injury.
Disconnect power and release all pressure from
the system before attempting to install, service,
relocate or perform any maintenance. Lock the power disconnect in the
open (off) position. Tag the power disconnect to prevent unexpected
application of power.
Install a screen around the inlet pipe to prevent
entrapment of swimmers.
3. Drain all water from the system before servicing.
4. Periodically inspect pump and system components. Perform routine
maintenance as required (See Maintenance, page 8).
5. Personal Safety:
a. Wear safety glasses at all times when working with pumps.
b. Keep work area clean, uncluttered and properly lighted replace
all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make the workshop child proof: use padlocks, master switches
and remove starter keys.
6. Do not pump chemicals or corrosive liquids. Pumping these liquids
shortens the life of the pumps seals and moving parts and will void
the warranty. Pump ONLY clear water.
7. When installing pump, cover the well to prevent foreign matter from
falling into well and contaminating the water and damaging internal
mechanical pumping components.
8. Always test the water from the well for purity before use. Check with
local health department for test procedure.
9. Complete pump and piping system MUST be protected against
below freezing temperatures. Freezing temperatures could cause
severe damage and void the warranty.
10. Do not run the pump dry or damage will occur and will void
warranty.
This pump is designed for indoor
installation only. Failure to install
indoors will significantly increase the risk of injury or death
from electrical shock.
All wiring should be performed by a licensed
or certified electrician.
11. For maximum safety, the unit should be connected to a grounded
circuit equipped with a ground fault interrupter device (GFCI).
12. Before installing the pump, have the electrical outlet checked by a
licensed or certified electrician to make sure the outlet is properly
grounded.
Read and save these instructions. This manual contains very important Safety Warnings and Operating Instructions. You will need to refer to it before attempting any installation or maintenance. Always
keep this manual with the unit so that it will be easily accessible. Failure to read and follow these warnings and instructions could result in property damage, serious injury or death.
Scan QR, or Log on to waynepumps.com and search your model number, to download a multilingual version of this manual
Escanee el código QR o visite waynepumps.com y busque su número de modelo para descargar una versión multilingüe de este manual
