■
Decide the position for
attaching the controller.
Consider the following points carefully when
deciding on the best location to install the controller.
• The controller and cable should not hinder perfor-
mance.
• The controller should not block of hamper access to
any of the bass guitar’s controls: volume, tone,
switches, etc.
• The AIX-103 controller should be positioned in an
easily accessible position.
• Do not position the controller in a manner that will
apply excessive force to the cord that connects the
divided pickup and controller.
• Do not position the controller in a manner that will
apply excessive force to the cord that connects the
direct bass guitar signal and controller.
• Do not position the controller in a manner that will
apply excessive force on the controller or cords
when the bass is placed on a guitar stand.
• Do not position the controller in a manner that will
apply excessive force on the AIX-103 or bass guitar
when the bass is placed in its case.
■
Determine the optimum method
of attaching the controller.
Refer to the “Select the Method of Installation”
section on page 5, and determine the optimum
method of attachment in regards to the attachment
position, materials, type of body, playing require-
ments, etc.
Before you install the controller, disconnect the
direct bass guitar signal cable and the 13-pin cable
from the controller.
■
Attach the Controller
Velcro Tape Attachment
1. With the male and female portions of the
Velcro still attached, cut the Velcro tape into
three pieces, and attach one side of the Velcro
to the underside of the controller.
2. Remove the backing from the other side of
the Velcro tape, and attach the controller to
the bass guitar’s body.
AI
X-
10
3
Attaching the Controller
13-pin
Cable
Bracket Attachment
1. Use the two screws (marked with arrows) on
the bottom of the controller to attach the
bracket to the controller.
2. Attach an appropriate number of cushion
(double-sided adhesive) to the bracket so that
the bass guitar surface does not come in
contact with the screw heads, and attach the
bracket to the guitar in the appropriate posi-
tion.
Divided
Pickup
Controller
Secure any excess cord to
the bass body with tape.
Direct Bass Guitar Signal Cable.
Bottom of Controller
Cut the Velcro into 3
pieces.
Cushion
(Double-sided Adhesive)
12
