________________________________________________________________________________________________________________________________________________
Mounting Outline - Beta 432H
Your Beta 432H is supplied with two threaded
432H in the two M4 brass inserts.
Once located you can mount your Beta 432H into the outline (as above) and then attach the supplied two
thumb nuts screws onto the nylon studs with your fingers. When
432H is mounted into your unit.
Please do not use pliers or any other tool to increase the tightness on the thumb nuts as this may cause the
nylon studs to break.
Beta Touch Computer
____________________________________________________________________________________________________________________________________________
Beta 432H
threaded nylon studs which are to be screwed into the rear of the Beta
Once located you can mount your Beta 432H into the outline (as above) and then attach the supplied two
thumb nuts screws onto the nylon studs with your fingers. When the thumb nuts are finger tight the Beta
Please do not use pliers or any other tool to increase the tightness on the thumb nuts as this may cause the
Beta Touch Computer
_____________________________________
Page | 27
studs which are to be screwed into the rear of the Beta
Once located you can mount your Beta 432H into the outline (as above) and then attach the supplied two
the thumb nuts are finger tight the Beta
Please do not use pliers or any other tool to increase the tightness on the thumb nuts as this may cause the