background image

 

________________________________________________________________________________________________________________________________________________

General Precautions 

 
Your  Beta  H  series  Touch  Computer  is  susceptible  to  damage  by  electrostatic  discharges.  In  order  to  avoid 
damage,  you  should  work  at  an  anti-static  bench  and  observe  normal  anti
static wrist strap connected to an earth point 

 

Where a wrist  strap  is not  available,  discharge  any static  charge  you may have built
point. Avoid any further movement that could build up another static charge. Touch an earth point from time 
to time to avoid further build-up, and remove the items from their anti
 

Electro-Static Discharges

If you are going to open up the unit, it is important to realise that the devices on the cards within this unit can 
be damaged by static electricity. Bear in mind that the damage caused by static electricity may vary from total 
destruction  to  partial  damage,  which  may  not  be  immediately  obvious.  This  could  have  an  effect  on  the 
product's  reliability  and  warranty.  Before  opening  the  chassis,  ensure  that  you  take  necessary  static 
precautions. Ideally you should work at an anti
possible, touch a suitable ground to discharge any static build up before touching the electronics. This should 
be repeated if the handling continues for any length of time. 

 

If it is necessary to remove a board or electronic assembly, place it into an anti
static electricity build up damaging the board. Metallised bags are preferred. Do not use black anti
for any item containing a battery because these tend to be conduct

On-Board Battery 

The processor board Real time Clock can be 
with this type of battery. If the battery is mistreated in any way there is a very real 
and personal harm. Under NO circumstances should it be short
100°C or burnt, immersed in water, recharged or disassembled.

 

Expired batteries remain hazardous and must be dispo

 

Le panneau de processeur est équipé d’une batterie de lithium. Le grand soin devrait être pris avec ce type de 
batterie. Si la batterie est mistreated il y a de dans de toute façon un possibility tr
et de mal personnel. Dans au cunes circonstances il est sous peu circuité, exposé aux températures au dessus 
de 100 degrés de centrigrade ou brûlé, immergé dans l’eau, rechargée ou dissassambled.
 
Les  batteries  expirées  restent  dazaedous  et  doivent  être  reejetées  d’une  façon  sûre,  selon  des  règlements 
locaux. 

 

 

 

Beta Touch Computer

____________________________________________________________________________________________________________________________________________

is  susceptible  to  damage  by  electrostatic  discharges.  In  order  to  avoid 
static  bench  and  observe  normal  anti-static  precautions.  Wear  an  anti

static wrist strap connected to an earth point 

before

 opening any packaging. 

Where  a  wrist strap is  not available, discharge  any static charge  you  may have built-up by touching  an earth 
point. Avoid any further movement that could build up another static charge. Touch an earth point from time 

up, and remove the items from their anti-static bags only when required

arges 

If you are going to open up the unit, it is important to realise that the devices on the cards within this unit can 
be damaged by static electricity. Bear in mind that the damage caused by static electricity may vary from total 

damage,  which  may  not  be  immediately  obvious.  This  could  have  an  effect  on  the 

product's  reliability  and  warranty.  Before  opening  the  chassis,  ensure  that  you  take  necessary  static 
precautions. Ideally you should work at an anti-static bench and wear an approved wrist strap or if that is not 
possible, touch a suitable ground to discharge any static build up before touching the electronics. This should 
be repeated if the handling continues for any length of time.  

electronic assembly, place it into an anti-static bag. This will prevent any 

static electricity build up damaging the board. Metallised bags are preferred. Do not use black anti
for any item containing a battery because these tend to be conductive and will discharge the battery.

can be fed from an external Lithium battery. Great care should be taken 

with this type of battery. If the battery is mistreated in any way there is a very real possibility of fire, explosion, 
and personal harm. Under NO circumstances should it be short-circuited, exposed to temperatur

°C or burnt, immersed in water, recharged or disassembled. 

Expired batteries remain hazardous and must be disposed of in a safe manner, according to local regulations.

Le panneau de processeur est équipé d’une batterie de lithium. Le grand soin devrait être pris avec ce type de 
batterie. Si la batterie est mistreated il y a de dans de toute façon un possibility très vrai du feu, d’expolosion 
et de mal personnel. Dans au cunes circonstances il est sous peu circuité, exposé aux températures au dessus 
de 100 degrés de centrigrade ou brûlé, immergé dans l’eau, rechargée ou dissassambled. 

dazaedous  et  doivent  être  reejetées  d’une  façon  sûre,  selon  des  règlements 

Beta Touch Computer 

_____________________________________

 

Page | 29  

is  susceptible  to  damage  by  electrostatic  discharges.  In  order  to  avoid 

static  precautions.  Wear  an  anti-

up by  touching an  earth 

point. Avoid any further movement that could build up another static charge. Touch an earth point from time 

static bags only when required 

If you are going to open up the unit, it is important to realise that the devices on the cards within this unit can 
be damaged by static electricity. Bear in mind that the damage caused by static electricity may vary from total 

damage,  which  may  not  be  immediately  obvious.  This  could  have  an  effect  on  the 

product's  reliability  and  warranty.  Before  opening  the  chassis,  ensure  that  you  take  necessary  static 

pproved wrist strap or if that is not 

possible, touch a suitable ground to discharge any static build up before touching the electronics. This should 

static bag. This will prevent any 

static electricity build up damaging the board. Metallised bags are preferred. Do not use black anti-static bags 

ive and will discharge the battery. 

Lithium battery. Great care should be taken 

possibility of fire, explosion, 

circuited, exposed to temperatures in excess of 

sed of in a safe manner, according to local regulations. 

Le panneau de processeur est équipé d’une batterie de lithium. Le grand soin devrait être pris avec ce type de 

ès vrai du feu, d’expolosion 

et de mal personnel. Dans au cunes circonstances il est sous peu circuité, exposé aux températures au dessus 

dazaedous  et  doivent  être  reejetées  d’une  façon  sûre,  selon  des  règlements 

Summary of Contents for Beta H Series
































Reviews: