100
ProxySG 900 Series Maintenance & Upgrade Guide
Install the Appliance into the Equipment Rack
This procedure describes how to mount the Blue Coat ProxySG 900 series appliance into the
newly installed slide-rails in the equipment rack.
!
WARNING! DO NOT
attempt to mount theBlue Coat ProxySG 900 series appliances alone!
If a mechanical lift is not used, Blue Coat recommends two people install the
Blue Coat ProxySG 900 series appliances.
To install the appliance into the equipment rack:
1.
Align the grooves of the inner rail with those on Rail_A and slide the appliance half-way
into the rack.
2.
Activate the white tab on the inner rail to slide the appliance fully into the equipment
rack.
3.
Tighten the rack screws securing the rail mounting brackets.
• For 4-post installations, the Rail_A and Rail_C brackets must be tightened.
• For 2-post mid mount installations, tighten both sets of Rail_B brackets.
• For 2-post front mount installations, tighten the Rail_A and Rail_B brackets.
4.
Tighten the thumbscrews on the retaining ears to secure the unit from sliding out of the
equipment rack.
e
TIP:
The slide release latches can be activated by pushing
or
pulling the latch.
Summary of Contents for ProxySG SG900-10
