Chapter 1: The SG200 Series
9
Mounting the SG200 in an Equipment Rack
To mount the SG200 horizontally into an equipment rack, use the rack-mounting brackets and screws; you
also need a Phillips screwdriver.
1
Use a Phillips screwdriver to attach the brackets to the SG200; use three screws on each side, as shown
in Figure 1-5.
Figure 1-5: Attach the Brackets to the SG200
2
While fully supporting the weight of the SG200, mount the brackets onto the equipment rack using
three equipment rack screws on each side (use the screws provided by the rack manufacturer).
Figure 1-6: Secure the SG200 to the Equipment Rack
Important:
Ensure that the SG200 is fully supported when mounting it in the equipment rack:
do not allow the brackets to support the SG200 until they are securely placed.
