Before attaching hose/regulator to
tank, be sure cylinder valve and
appliance valves are OFF.
The Q.C.C.1 cylinder valve has an internal
back check module which will not allow gas
to flow until a connection has been made.
The valve is turned off by rotating the
handwheel (Fig. 3, Use and Care)
Clockwise (left to right) until it stops. When
attaching regulator to tank, make sure that
the small probe (Fig. 7B) in the nipple is
centered in the mating Q.C.C.1 cylinder
valve, turn the right hand threaded Q.C.C.1
nut onto the valve in a clockwise motion
until there is a positive stop. DO NOT USE
A WRENCH, HAND TIGHTEN ONLY.
IMPORTANT:
Ensure hose assembly
does not contact the casting, or any other
parts which will get hot.
Q.C.C.I. NUT
TANK
HOSE/REGULATOR
WARNING:
Before proceeding with the following steps, ensure you have read: • L.P. Gas Cylinder • Hose and Regulator
Sections of the
USE AND CARE INSTRUCTIONS
located at the front of this manual. The L.P. gas cylinder, if supplied with your grill, has been
shipped empty for safety reasons. The cylinder must be purged of air, and filled, prior to use. Follow all directions under
"L.P. Gas Cylinder - Filling"
section of the
Use and Care Instructions.
FIG.15
HOSE/REGULATOR
When using your grill, it is best to:
1 - Place the propane tank into the tank pocket as shown, with the
propane tank valve facing towards the FRONT of the cart.
2 - Attach hose and regulator as shown, facing towards the FRONT
of the cart at all times during operation. The hose should not touch
the firebox or the grease pan/heat shield.
3 – Perform a leak test after installing the propane tank, as instructed
in the "cleaning & maintenance" section of this manual(page 9).
ADDITIONAL SAFTY PRECAUTIONS TO PREFORM
38
