9
ASSEMBLY INSTRUCTIONS
9.
Locate the (2) screws on underside of
hanging bracket and loosen screws.
Place rounded part of slotted hole in
canopy over the loosened screws in
hanging bracket and push up. Make
sure all wires are tucked into the
canopy and will not be pinched,
including the black antenna wire.
Twist canopy to lock. Tighten screws
securely.
10.
INSTALLING THE BLADES
–
Insert the
blade into the blade slot around the
motor housing and line up the three
(3) holes at the end of the blade with
the 3 holes in the motor housing.
Secure the blade to the fan using (3)
blade screws and (3) washers.
Repeat for the remaining blades
.
NOTE:
Use the cut-out in the bottom
of motor housing for easier
accessibility to blade holder screw
holes.
11.
Line up the (2) holes on the top of the
blade medallion with the (2) holes on
the blade. Using (2) blade medallion
screws and washers, attach the blade
medallion onto the bottom of the
blade by inserting the blade medallion
into the two holes on the blade and
screwing in from the top.
PROGRESS CHECK
–
YOUR FAN
BLADES SHOULD LOOK LIKE THIS
10
Blade Screw & Washers
Blade Medallion Screws & Washers
11
9
