10/3/2018
Newton Gripper
http://docs.bluerobotics.com/newton-gripper/#specifications
6/17
Install Newton Gripper Penetrator
To install the Newton Gripper into the end cap, you will need the following parts and tools:
1 x Newton Gripper assembly
1 x Penetrator Nut (Red)
1 x Penetrator O-ring
1 x Silicone Grease – 10g Tube
1 x Isopropyl Alcohol Wipe
1 x Penetrator wrench
1. Wipe the exterior surface of the electronics enclosure endcap clean with isopropyl alcohol or isopropyl alcohol wipes, and
make sure it is free of any particles in the areas where the penetrator O-ring will sit.
2. Remove the O-ring from the bag and apply silicone grease to it.
3. Install the O-ring onto the Gripper cable penetrator.
4. Install the Gripper cable penetrator on to the end cap in the hole you previously removed the blank penetrator from. Tighten
to nger tight, then use the provided wrench to tighten it an additional ~1/16 of a turn. If you can’t loosen it with your ngers, it
is tight enough.
