9
Operation
Lighting Pilot Burners
1.
Depress gas control knob and rotate anti-clockwise to ‘PILOT’ position.
2.
With control knob depressed, press piezo ignition button on front control panel until pilot burner
ignites. Pilot ignition can be viewed through openings in control panel.
3.
Hold in gas control knob for approximately 10 seconds, then release. Pilot burner should remain
alight. If not repeat Items 1 to 3.
4.
Repeat Items 1 to 3 to light second pilot burner.
5.
Rotate gas control knob anti-clockwise to first stop for ‘FULL’ flame.
6.
Depress and rotate gas control knob fully anti-clockwise for ‘LOW’ flame.
Using Griddle
1.
Light pilot burners as shown above.
2.
If starting from a cold start, turn gas controls to ‘FULL’ flame position and allow griddle plate to
preheat for 10 minutes.
3.
Place product to be cooked onto griddle plate.
4.
For intermediate heat, position gas control knob between ‘HIGH’ and ‘LOW’ positions to achieve
desired heat.
5.
During idle periods, burners can be turned down to maintain an appropriate griddle plate
temperature or gas controls can be set to ‘PILOT’ position as required.
Using Toaster
1.
Light pilot burners as shown above.
2.
If starting from cold, set burners to ‘FULL’ flame position and allow 5 minutes preheat before
commencing toasting.
3.
Adjust rack position to desired height.
4.
Place product on rack to toast.
5.
Best toasting results are achieved using shaded area of toast rack as per diagram below.
6.
With main burners alight, individually controlled burners can be operated to suit food quantity
requirements.
7.
Each burner is operated by an ‘OFF’ / ‘PILOT’ / ‘HIGH’ / ‘LOW’ gas control. ‘HIGH’ position is
recommended for most grilling, cheese melting functions and ‘LOW’ position for a reduced heat
setting.
OPTIMUM
TOASTING AREA
IMPORTANT:
Should any abnormal operation like;
- ignition problems,
- abnormal burner flame,
- burner control problems,
- partial or full loss of burner flame in normal operation, be noticed, appliance requires
IMMEDIATE service by a qualified service person and should not be used until a service is
carried out.
Summary of Contents for Evolution G55T
Page 20: ......
