Blue Seal Evolution G55T, Installation And Operation Manual

14 

Gas Conversion and Specifications 

Conversion Procedure 

NOTE: 



These conversions should only be carried out by qualified persons.  All connections must 
be checked for leaks before re-commissioning the appliance. 



Adjustment of components that have adjustments / settings sealed (e.g. paint sealed) can 
only be adjusted in accordance with the following instructions and shall be re-sealed be-
fore re-commissioning this appliance. 



For relevant gas specifications refer to 

‘Gas Specifications Tables’ 

at rear of this section. 

Main Burners 

1. 

Remove the following:- 



Control Panel. 



Toasting Rack. 



Main Burner. 

2. 

Remove injectors and replace with correct size injectors 
as shown in ‘Gas Specifications Tables’ at rear of this  

section. 

3. 

Refit the following:- 



Main Burner. 



Toasting Rack. 

Pilot Burners 

1. 

Disconnect the following:- 



Pilot Supply and Thermocouple Tubes from Gas  
Control Valve. 



Pilot Assembly from Griddle Toaster. 

2. 

Remove pilot injectors and replace with correct size pilot 

injectors as shown in ‘Gas Specifications Tables’ at rear of 

this section. 

3. 

Re-connect the following:- 



Pilot Supply and Thermocouple Tubes to Gas Control 
Valve. 



Pilot Assembly to Griddle Toaster. 

Low Fire Adjustment 

1. 

Light main burners and check flame size on ‘Low’ position. 



Adjust low fire adjustment screw on burner gas control valves to 
obtain desired flame size. 

NOTE: ‘Low Fire Adjustment Screw’ should be sealed with coloured 

paint on completion of low fire adjustment. 

2. Refit 

control 

panel. 

3. 

Refit gas control knobs to gas control valves. 

Wing Nut 

Main Burner Injector 

Thermocouple 
Connection 

Pilot Securing 

Screws 

Pilot Gas Supply Tube 

Ensure Appliance is isolated from gas supply before commencing servicing. 

Caution 

Low Fire Screw