10
Operation
Lighting the Pilot Burner - (Target Top)
1.
Remove centre casting with the casting removal tool.
2.
Depress the control knob and rotate anti-clockwise to the ‘PILOT’ position.
3.
With the control knob depressed, manually light the pilot burner located in front of the main burner.
4.
Hold in the control knob for approximately 10 to 15 seconds, then release.
5.
The pilot burner should remain alight. If not repeat
Items 2 to 4
above until the pilot burner lights.
Lighting the Main Burner - (Target Top)
1.
Ensure that pilot burner is alight by checking through the hole in the centre of the front control panel
or by removing the centre casting with casting removal tool.
2.
Rotate the gas control knob anti-clockwise to the position marked ‘HIGH’.
3.
The main burner will now ignite automatically off the pilot burner.
4.
Once lit the main burner will be burning at full rate. For a lower heat turn the gas control knob fully
anti-clockwise to the ‘LOW’ position.
5.
Also for intermediate heat, position the gas control knob between the ‘HIGH’ and ‘LOW’ positions.
NOTE: Always set the gas control knob to the ‘HIGH’ position when lighting the main burner. If the
pilot burner goes out during normal operation wait 5 minutes before relighting.
6.
The cast iron work surface has a heat pattern that can be used effectively by positioning cooking
pans etc. appropriately according to heat requirement.
350 / 400
300 / 350
250
/ 300
200 / 250
Heat Pattern for target top on full heat (°C)
Heat Pattern for target top on Low Heat (°C)
200 / 250
150 / 200
250 / 300
Fig 4
Fig 5
Summary of Contents for Evolution G570
Page 7: ...5 Dimensions G570 ...
Page 25: ......
