10
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
Assembly
This model is delivered completely assembled. Ensure that the legs are securely attached.
NOTE:
•
This appliance is fitted with adjustable feet to
enable it to be positioned securely and level on
uneven floors. This should be carried out on
completion of the gas connection. Refer to the
'Gas Connection Section'.
•
This appliance can also be fitted with rear rollers to
enable the appliance to be easily moved for
positioning and cleaning purposes. If desired,
these rollers are supplied in the packaging, with
the appliance. See below for fitting instructions.
Optional Accessories (Refer to Replacement Parts
List)
•
Plinth Kit. For installation details, refer to the
instructions supplied with each kit.
Fitting Rear Rollers.
1.
Raise the appliance from the floor by approx.
75mm using suitable lifting equipment (i.e.
Palletiser / Forklift) to allow the rear adjustable
feet to be removed.
2.
Unscrew and remove both the rear adjustable
feet from the rear leg housings.
3.
Fit the rear roller to the rear leg housing and
align the screw hole in the side of the rear leg
housing with the threaded hole in the rear
roller.
4.
Secure the rear roller to the leg support with
the bolt supplied and tighten the bolt using a
10mm A/F spanner.
5.
Fit the second roller and tighten.
6.
Lower the appliance back to the floor and
adjust the front adjustable feet to level the
appliance.
Installation
Combustible Surface Non Combustible Surface
Left / Right Hand Side
50mm
0mm
Rear
50mm
0mm
Fig 1
Appliance
Base
Adjustable
Foot
Rear Roller
Assy
Rear Leg
Housing
Roller
Locating Bolt
gpd.sunwayinfo.com.cn
gpd.sunwayinfo.com.cn
gpd.sunwayinfo.com.cn
