-34-
Revision 5/F3534
©
Moffat Ltd, April 2005
Turbofan Convection Oven
2 Screws
Two Screws
Two
Screws
6.3.20 INNER GLASS (E311)
6.3.19 OUTER GLASS (E311)
1) Open
door
2) Undo two screws securing Turbofan cover
plate to oven, and remove cover plate.
1) Remove the outer glass as above. Uncrimp
the retaining lugs of the window spacer and
remove the spacer and glass.
3) Remove LH screw whilst supporting the door.
Lift bracket and remove door from oven.
2) To replace, ensure the silicone rubber seal
has not been displaced. Clean the glass and
refit it. Place the window spacer in position
and crimp the retaining lugs over to hold the
glass in place. Refit outer glass as above.
Retaining
Lugs
Figure 6.3.31
4) Remove screws securing door handle.
Figure 6.3.28
Figure 6.3.27
LH Screw
5) Remove two screws in top trim and two
screws in bottom trim of door, and remove
trim panels.
Screws
Figure 6.3.29
6) Lift outer glass away from door.
7) To replace, ensure that the two silicone
rubber seals are in place on the left hand and
right hand side of the door frame. Clean the
inside of the glass and refit it, ensuring that
the silicone rubber seals cover the outer
edges of the glass. Refit the bottom trim.
Figure 6.3.30
6.3.21 INNER GLASS SEAL (E311)
1) Remove the door inner glass (refer 6.3.20).
2) The inner glass seal can now be removed and
replaced.
NOTE:
When fitting new seal, ensure join is at
top of door.
