7
ASSEMBLY
NOTE: WE STRONGLY ADVISE ONLY FINGER TIGHTENING BOLTS
DURING INITIAL ASSEMBLY. ONCE ALL BOLTS ARE INSERTED, FULLY
TIGHTEN ALL BOLTS. DO NOT OVERTIGHTEN.
STEP 1
Insert the ash catch connector [F]
through the ash catch [E] and into the
bottom of the fire bowl [C]. Secure the
ash catch connector with two nuts [I],
one on either end of the connector.
STEP 2
Insert four M6 x 15 mm bolts [G]
through washers [H], into the holes
in the fire bowl [C] from the top and
then through the holes in the base [D].
Secure with washers [H] and nuts [I]
from underneath the base.
E
F
C
I
G
H
H
D
C
I
I
