9
Blue Sky Sub 12D
Owners Manual, V1.0
Connection Steps
Position the Sub 12 where you intend to use it in your studio system.
The following steps describe how to connect Blue Sky Sub 12D to your studio system:
1. Turn off all power sources and components before connecting inputs and outputs.
2. Neatly arrange and organize wiring to and from the Blue Sky Sub 12D and all components.
Separate AC wires from audio cables to prevent hum or other unwanted noise from being
introduced into the system.
3. If you are using a Blue Sky Sub 12D in a 2.1 mode, connect the outputs of your mixing console
or computer workstation to the appropriate analog balanced XLR input, or AES XLR input on the
Sub 12D, THEN, connect via the Analog or Digital outputs on the Sub12D to the required input on
the Sat 6D.
4. If you are using Digital inputs, please make sure you are using 110-ohm AES digital cables, not
standard balanced cables. They are not the same.
5. Connect the supplied AC power cord to the IEC power cord receptacle.
6. Plug the AC power cord into AC power outlet.
IMPORTANT !
If the Sub 12D is used with Blue Sky Sat 6D monitors, it is recommended that you power up the
Sub 12D before the Sat 6D monitors, and turn the Sub 12D off last, after first turning off the Sat
6D monitors.
Always mute or fully attenuate the input level when switching sources. Do not change input
connections to the Sub 12D when the speaker is powered on.
