INSTALLATION AND OPERATION OF THE DEVICE
Open the package and dispose of all its materials in an environmentally safe
manner. Waste electrical equipment does not belong to household waste.
Electrical and electronic equipment must be disposed of separately from general
household waste through government waste disposal facilities in accordance with
directive 2002/96/EC and national legislation.
This can be done by returning it, when buying a similar device
to an authorized collection point for the recycling of
equipment waste.
The device can be mounted on the floor with a distance from the wall of 10 cm.
Insert the package cable into the (11) socket of the app
corresponding socket. Turn on the device from the ON / OFF button (6) located
above the power switch.
Adjust the motor speed by the analog regulator (7) located next to the power
button (analog models).
Adjust the motor power from the on/off hand control (DIGITAL models)
Press and hold the button (16) on the air quality diagnostic instrument until the
indications (17) appear.
Air quality detector with temperature, humidity, carbon dioxide, TVOC and
formaldehyde (HCHO) sensor.
BASIC EQUIPMENT AND TECHNOLOGICAL PRESENTATION OF THE DEVICE
FILTRATION PROCEDURES
Dust filter:
For therestraining of Pm10 particles according to ISO16890 and
protection of the absolute filter. Large dust capacity and very stable and durable
structure. The pre-filter removes dust, hairs and other larger particles.
Activatedcarbonfilter:
Elimination of pollutants such as HCS, SOx, NOx, CH2O,
H25, chlorine compounds. The ejected air follows EU regulations.
HEPAfilter:
They are used in the medical industry for applications mainly in
operating rooms and places that require prevention of the spread of bacteria and
viruses. They can collect particles as small as 0.3 µm
applications is accompanied by strict maintenance and replacement protocols.
Fibershield™ Filter:
Is a Nylon, non-woven antimicrobial fiber, infused with
specified concentrations of silver particle technology.
This new technology adds an important layer of protection, as
inactivate 99% of microbes that come into contact with it.
The product of PureAir FiberShield
TM
showed the Antiviral Activity Rate of 96.58%
for SARS-CoV-2, 98.13% for H1N1, 98.48% for H7N9, and 98.62% for Rhinovirus
(host cell: MDCK) according to ISO 18184-2019 based on the test reports WP
20096694-JC (01-04)of the third-party independent lab testi
MAINTENANCE AND SUPERVISION INSTRUCTIONS
FILTERMAINTENANCE:
To maintain the filters, the device must be turned off by the central Switch (6) and
unscrew the visiting Port (5). Pull out each strain of the filters and after cleaning them,
reposition them in the exact same arrangement and close the visiting port.
The device is designed so that you can easily supervise and maintain its equipment in
complete safety. Under normal conditions, filters need cleaning every
can clean them with a vacuum cleaner. Never clean the filters with water
damaged.
LAMPS MAINTENANCE AND SUPERVISION:
To maintain the lamps, close the appliance by the main switch (6) and unscrew the
visiting Port (5). Pull out each bulb stem and after cleaning their surface with a cotton
cloth, reposition in exactly the same arrangement and close the visiting Hatch.
Under normal conditions, lamps need cleaning every 1 year. Never clean the lamps
with water because they will be damaged.
INSTALLATION AND OPERATION OF THE DEVICE
Open the package and dispose of all its materials in an environmentally safe
manner. Waste electrical equipment does not belong to household waste.
electronic equipment must be disposed of separately from general
household waste through government waste disposal facilities in accordance with
This can be done by returning it, when buying a similar device or by handing it over
electrical and electronic
The device can be mounted on the floor with a distance from the wall of 10 cm.
Insert the package cable into the (11) socket of the appliance and then into the
on the device from the ON / OFF button (6) located
Adjust the motor speed by the analog regulator (7) located next to the power
from the on/off hand control (DIGITAL models).
Press and hold the button (16) on the air quality diagnostic instrument until the
Air quality detector with temperature, humidity, carbon dioxide, TVOC and
BASIC EQUIPMENT AND TECHNOLOGICAL PRESENTATION OF THE DEVICE
according to ISO16890 and
capacity and very stable and durable
filter removes dust, hairs and other larger particles.
Elimination of pollutants such as HCS, SOx, NOx, CH2O,
H25, chlorine compounds. The ejected air follows EU regulations.
They are used in the medical industry for applications mainly in
operating rooms and places that require prevention of the spread of bacteria and
They can collect particles as small as 0.3 µm.Their use in commercial
companied by strict maintenance and replacement protocols.
woven antimicrobial fiber, infused with
This new technology adds an important layer of protection, as FiberShield™ will
showed the Antiviral Activity Rate of 96.58%
2, 98.13% for H1N1, 98.48% for H7N9, and 98.62% for Rhinovirus
2019 based on the test reports WP-
party independent lab testing.
STERILIZATION PROCEDURES
Ultraviolet technology:
the models of the BLUE STERI series are equipped with
UVC lamps without Ozon production. Low
mercury, but a special compact amalgam, with alloys of noble metals. Long
life (up to 9,000 hours) with greater UVC efficiency than conventional lamps (up to
45%).
Bipolar ionization:
the technology produces a natural bioclimate rich in positive
and negative oxygen ions. All products have been designed and tested in
accordance with applicable UL or ETL safety standards. PLASMA CONTROL
devices can collect particles as small as
standard filters. The heat of electrons is not perceived due to their minuscule mass.
Plasma constitutes the most high energy state of matter and is characterized by the
energy and density of electrons.
Self-cleaning spray system:
the innovative patented automatic disinfection
process of the device aims to directly sterilize the internal chamber of the device
and the surfaces of the filters. For the above procedure the device has an advanced
nanopspray system dispersing on the surface disinfectant liquid Kohrsolin FF,
complying with the European biocidal products directive. Bactericidal MRSA,
fungicide, according to VAH/DGHM/EN1276/en 1275/EN 1650 active against all
covered viruses, hepatitis B / HIV and h
disinfection and simultaneous cleaning of high and
floors and walls of operating rooms, ICU
dispensaries, etc. It is a liquid of pleasant
surfaces and biologically degradable.
marketingauthorization approved byNational Organization for Medicines
MAINTENANCE AND SUPERVISION INSTRUCTIONS
maintain the filters, the device must be turned off by the central Switch (6) and
unscrew the visiting Port (5). Pull out each strain of the filters and after cleaning them,
reposition them in the exact same arrangement and close the visiting port.
ice is designed so that you can easily supervise and maintain its equipment in
complete safety. Under normal conditions, filters need cleaning every 3-5 weeks. You
can clean them with a vacuum cleaner. Never clean the filters with water,as they will be
To maintain the lamps, close the appliance by the main switch (6) and unscrew the
visiting Port (5). Pull out each bulb stem and after cleaning their surface with a cotton
reposition in exactly the same arrangement and close the visiting Hatch.
Under normal conditions, lamps need cleaning every 1 year. Never clean the lamps
STERILIZATION PROCEDURES
the models of the BLUE STERI series are equipped with
UVC lamps without Ozon production. Low-pressure lamps that do not contain
mercury, but a special compact amalgam, with alloys of noble metals. Long service
life (up to 9,000 hours) with greater UVC efficiency than conventional lamps (up to
the technology produces a natural bioclimate rich in positive
and negative oxygen ions. All products have been designed and tested in
accordance with applicable UL or ETL safety standards. PLASMA CONTROL
devices can collect particles as small as 0.001 µm, up to 10 times faster than
standard filters. The heat of electrons is not perceived due to their minuscule mass.
Plasma constitutes the most high energy state of matter and is characterized by the
the innovative patented automatic disinfection
process of the device aims to directly sterilize the internal chamber of the device
and the surfaces of the filters. For the above procedure the device has an advanced
stem dispersing on the surface disinfectant liquid Kohrsolin FF,
complying with the European biocidal products directive. Bactericidal MRSA,
fungicide, according to VAH/DGHM/EN1276/en 1275/EN 1650 active against all
covered viruses, hepatitis B / HIV and hepatitis C. Kohrsolin FF covers the needs of
disinfection and simultaneous cleaning of high and unprotected surfaces such as
floors and walls of operating rooms, ICUs, patient wards, toilets, lab benches,
dispensaries, etc. It is a liquid of pleasant smell, low foaming, compatible with metal
surfaces and biologically degradable.It bears the "CE" marking and has a
National Organization for Medicines.
