FIG. 11
15.
Attach the Control Box (#16) to the middle of
Tube 11
(#11) using two Bolts (#30) as shown in FIG.11A.
16. Run the rest of the Control Wire through the loops on the bottom side of the Ball Return Net (#35). Hold the Control
Wire on
Tube 11
(#11) using the Self-Stick Straps (#34) as shown in FIG.11.
ASSEMBLY INSTRUCTIONS (CONT.)
1
2
Control Wire
X1
16
X2
30
X2
34
FIG.11
11
16
34
30
11
35
FIG. 12
14
Sensor Wire
Sensor Wire
Electronic Scorer
Control Wire
FIG. 12A
ON / OFF
CONTROL
WIRE /
CONTROL
CABLE
VISITOR
FIG. 12
17.
Connect the Sensor Wire from Switch Sensor (#15) to the Electronic Scorer (#14) as shown in FIG.12.
Connect the Control Wire to the Electronic Scorer (#14) as shown in FIG.12 and 12A.
FIG.11A
NOTE: Control Box Wire
must
be plugged into Electronic Scorer and Controller turned on,
along
with Electronic
Scorer, for Scorer to work. Scorer will
NOT
work until this is done.
