Blueant Interphone none, User Manual

11

Advanced Functions 

 
Driver to Passenger  or Bike to Bike INTERCOM

The BLUEANT INTERPHONE has motorcycle intercom system that allows driver 
to passenger conversations. This intercom features full-duplex communication so 
driver and passenger may enjoy simultaneous conversations just like on the 
telephone. To use this feature you must have two BlueAnt InterPhone Headsets 
 
 

Intercom Pairing Procedure: 

1.  Prepare two BLUEANT INTERPHONES. 

      Note: Make sure to switch off the phones paired to these two headsets. 
2.  Set the two units to pairing mode (from off, press and hold the 

MFB(1) 

of the 

BLUEANT INTERPHONE for about 5 seconds or until you hear the 2

nd

beep).  

3.  When the two are set to pairing, press 

Volume Up(3)

 button of BLUEANT 

INTERPHONE N°1 for about 5 seconds (1

st 

beep followed by 5 successive 

beeps will be heard and then BLUEANT INTERPHONE N°1 turns off). 

4.  Wait for 3 seconds and then switch on BLUEANT INTERPHONE N°1. 
5. Press

 Volume Down(4)

 button of BLUEANT INTERPHONE N°2 for about 5 

seconds (1

st

 beep followed by 5 successive beeps will be heard). BLUEANT 

INTERPHONE N°2 pairing blink will change to blinking blue while BLUEANT 
INTERPHONE N°1 will again turn off. 

6.  Wait for 3 seconds and then switch on again BLUEANT INTERPHONE N°1. 
7. Press 

MFB(1) 

of BLUEANT INTERPHONE N°1 for about 3 seconds (2

nd

beep) to connect to BLUEANT INTERPHONE N°2. 

   The set-up has been successful. Both headsets are now connected. Full-   
   duplex conversations can be made.  
   Note: This has to be done only once every time you want to use 2 different  
   BLUEANT INTERPHONE together. 

Using as an Intercom: 

To switch from phone to intercom, press 

MFB(1)

 for 3 seconds or until 

you hear the 2

nd

 beep. 

To switch from intercom to phone, press 

MFB(1) 

for 1 second or until 

you hear the 1

st

 beep. 

 Important 

Notes: 

1. Both BLUEANT INTERPHONES’ must be in intercom mode to allow 

intercom. 

2.  When the BlueAnt Interphones go out of range of each other they will 

drop out of intercom mode and will need to be manually reconnected 
when back in range. This is done by simply pressing and holding the MFB