Installing the Clip Mount
Important:
There are 2 types of Headset Clips included
in this package. Either can be used with full
or open faced helmets, on either side of
the helmet.
- Headset Clip Mount with Fastening Clamp.
(removable)
- Headset Clip Mount with Adhesive. (fixed)
Use the one which best suits your helmets design.
Using the Headset Clip Mount with Fastening Clamp
1.
Using the provided
screw driver, loosen
the Clips’ screws
enough to allow the
Clip to slide onto
either side of the
Helmets’ shell.
2.
Make sure you put
the clip under the helmets padding.
3.
Adjust the Clip until you find the best location for your helmet.
4.
Tighten
the screws to hold the clip firmly in place.
4
Note:
If the helmet’s shell is too
thick, the
Spacer
(provided) may
be needed to put in between the 2
parts
of the Headset Clip, as
shown in the picture on the right.
Use the additional longer screws
(provided) for this purpose.
