English
Blue
Card
Miscellaneous
After communicating with the PC, the BP-2002S will become
capable of reading signal cards after 5 seconds.
The interval between signal card readings should be longer than 5
seconds.
Working As Card Reader
The BP-2002S guard tour reader can be used as a standard signal
card reader used for various applications.
Troubleshooting
After reading a card, 1 beep with 4 flashings, followed by 4 beeps
with 4 flashes
The reading was successful, but the reader’s internal clock should
be calibrated with the PC before further readings are made.
After reading a card, 4 beeps with 4 flashes
The reading was not successful. The reader memory is full. The
data needs to be uploaded before more readings can be made.
After reading a card, 1 beep with 4 flashes, followed by 8 beeps with
8 flashes
There is an error within the reader. It needs to be connected with the
computer have its data uploaded then initialized.
The LED continuous flashes
The battery is low and needs to be charged. Please follow the
“BP-2002S Reader Battery Change Instruction” to change the
battery.
Failed to upload data to the software and followed by 8 beeps with 8
flashes
There is an error when uploading data. It needs to be initialized.
Important, all of the data saved in the reader will be removed.
When the reader communicate with the software followed by 1 beep
and 1flash
There is a hardware error within the reader. It needs to be returned to
the manufactory.
Failed to scan signal card
Solution 1: after communicating with the PC, wait 5 seconds before
starting to scan signal cards again
