7
Warnings:
Do not attempt to install the lights whilst the boat is in the water.
Installation:
Fig 1 showing how the Gel connector is wired up.
Fig 2 showing how the finished Gel connector should look when finished.
Ensure that the black outer sheath is inside the gel connector.
The IP68 GEL CONNECTOR MUST BE INSTALLED CORRECTLY OR YOU WARRANTY WILL BE VOID.
Fig 1
Fig 2
Testing:
Test the light before installation ensuring that you use the correct voltage and the light is illuminated
correctly.
After installation ensure again that the light is illuminated correctly before the boat goes back into
the water and the lens label is removed.
After your boat goes back into the water check internally for water tightness around where the light
is installed.
Maintenance:
Regularly check the installation for water tightness.
Only clean the light with a soft bristle brush.
Warranty:
Your product has a 2 year limited warranty for defects.
For any warranty issues please contact your point of sale retailer or go to
for further advice.
Bluefin
LED
Cottage Farm, Cottage Lane,
Norton Juxta Twycross, Atherstone. CV9 3QH
Sales - Tel: 07950 909048
Email:
Service - Tel: 01827 880450 Email:
Administration - Tel: 01827 880450
Email:
samantha.barrie@bluefinled.com
Registered Address:
Square Rig Limited, t/a Bluefin Led, Cottage Farm, Cottage Lane, Norton Juxta Twycross, Atherstone, CV9 3QH
Company Registration Number:
08871451
VAT Number: 179 2690 64
Image showing how to
wire the Gel Connector to
the light and Fuse holder
Please use fuse
instructions within
the manual to wire
the fuse
Power
In
from
boat
power
Driver
cable
Negative wire
to boat power
in
Heatshrink
Summary of Contents for GW16IFM
Page 8: ...8...