4
Thank you for choosing Bluefin LED underwater lights, our products have been designed and tested
rigorously to ensure the optimum performance and longevity.
Please ensure that your product is installed as per our instructions below, failure to do so may
invalidate your warranty.
Specs: electrical/fuse ratings
Voltage
Current
Fuse rating
LM48CC Drivers
24V only
24V-6.5
8amp
Warnings:
•
Do not attempt to install the lights whilst the boat is in the water.
•
Ensure that the correct voltage is used for the light and Driver.
•
Ensure that the in line fuse is installed with the correct fuse rating per the Driver installed.
•
Ensure that the supplied gel connector is used to make a watertight connection or your
warranty will be
Void.
•
If you wish to connect your Colour change lights and drivers to your own DMX Controller
please contact BluefinLED beforehand for further advise.
Installation:
Electrical connection:
•
Ensure that the supplied gel connector is used to make a watertight connection or your
warranty will be
Void (see fig 6/7)
•
Attach the Driver power cable to the VDC power on the boat ensuring that you use the in line
fuse supplied connected to the positive(red) wire, ensure that you use the heatshrink
provided to create a water tight fit into the fuse holder. (see fig 2)
•
Plug the Light cable connector to driver as per Fig 1 aligning the white lines on the
connectors to ensure the connector pushes home correctly.
•
Plug the DMX controller cable (if supplied fig 3) into the first driver DMX IN connector as per
Fig 1.
•
Plug the DMX Interlink cable (Fig 4) into the DMX OUT connector on the first driver Fig 1.
•
You can now daisy chain the drivers using the DMX Interlink cables going from the OUT DMX
to the IN DMX on the next driver.
•
When completing a circuit you must plug the DMX Terminator plug (Fig 5) into the last
drivers DMX OUT to complete the circuit.
Fig 1 (Driver)
Fig 2 (Fuse connection)
Crimps for
positive
wires (ensure
that these
are mounted
into the
holder
before they
are crimped)
Heatshrink
for water
tight seal
to the fuse
holder
Fuse holder
Positive wire
from Driver
Light cable
connector
24VDC
Power cable
DMX IN
Connector
DMX OUT
Connector
Summary of Contents for GW20IFM
Page 7: ...7...
