3
Fig 1
Fig 2
Fig 3
Fig 4 showing how the Gel connector is wired up.
Fig 5 showing how the finished Gel connector should look when finished.
Ensure that the black outer sheath is inside the gel connector.
The IP68 GEL CONNECTOR MUST BE INSTALLED OR YOU WARRANTY WILL BE VOID
Fig 4
Apply Sealant
around this edge
and around the
cable gland
Fuse holder
Crimps for
positive wires
(ensure that
these are
mounted into
the holder
before they are
crimped)
Positive wire
from Light
Heat shrink for
water tight
seal to the fuse
holder
Please ensure
outer sheath is
inside the gel
box
Image showing how to
wire the Gel Connector to
the light and Fuse holder
Please use fuse
instructions within the
manual to wire the fuse
Power
In
from
boat
power
Light
cable
Negative wire
to boat power
in
Heatshrink
Summary of Contents for P24
Page 6: ...6...
