6
Remove the communication data line
Will have been connected to the cable gun OY20 on communication cable, need a size and
remove the hole on the gun body is suitable for the needle (such as paper clips) as
auxiliary tool, as shown in the above, the paper clips at one end of the straight in order
to remove the hole plug into.The remaining steps are:
1. If connecting the host and scanning gun with the rs-232
data line, please unplug the power adapter first.
2. Insert the needle into the disassembly hole and press it hard.
3. Gently pull out the end of the data line and the scanning
gun and pull the needle out of the hole.
4. Unplug one end of the data cable from the host.
Boot\Hibernate\Shutdown\Restart
Boot
:
Connect the cable gun to the host. The
BLST-20
cable gun is switched on
automatically and in a dormant state (factory setting).
Hibernate
:
When the scan gun is over a certain period of time without reading the barcode,
it will automatically go into hibernation.
Shutdown
:
Remove the data line connecting the
BLST-20
cable gun; Remove the USB cable plug on
the host computer; Remove the power adapter plugged into the rs-232 data.
Restart:If
BLST-20
is dead or no response, please shut down and restart.
Summary of Contents for BLST-20
