33
Continuous mode
Continuous mode is the way of continuous loop of the scanner to shoot, read and output
information. In this mode, the scanner recognizes the output, whether it is the same bar
code or not.
In continuous mode, the trigger level control can be used to suspend continuous reading or
continuous reading. In the case of continuous reading, it will be suspended if the trigger
level of 30ms is maintained. When the reading status is suspended, the same level of trigger
level is maintained above 30ms and then retracted, so it continues to read.
Continuous mode
Single read time limit
In continuous mode, it refers to the maximum duration of the acquisition and identification
before the success of the reading, and after the timeout, it will enter the interval of not
collecting the reading. The reading time is 100ms, and it can be set to 0.1~25.5s. When set to 0,
it stands for an infinite length of time. Set way to refer to appendix E.
Single read time limit
Read the interval length setting
Read the interval length setting
It refers to the interval between two readings. Regardless of the success or
failure, there will be a set interval between the two readings, which will not be
read during this interval. The intermittent time is 100ms and can be set to
0~25.5s. , the default length is 1000ms. Set way to refer to appendix E.
Summary of Contents for BLST-20
