4
Index for controller:
1. Press
and hold for 2s to turn on the light.
2. Press
and hold for 2s turn off the light.
3. Press
to change modes and set the light’s current time.
4. Press
to set different LED brightness ( 0 - 3 0 )
Operation instruction:
You can set the running time period for each mode as you like. If the total is less than 24 hours, the light will be OFF after the Night time mode
till to the next circle. If the total is more than 24 hours, the part over 24 hours will be ignored.
Current Time setting:
Before using timer, current time must be set.
Step 1:
press seven times, the screen will flash with hour number.
Then press / to adjust it.
Step 2:
after setting the hour, press again, the screen will appear the
flash with minute number, then press / to adjust it.
Step 3:
If no other setting is done afterwards, then after 8 seconds your
previous setting will be saved automatically or press to return to the
automatic running state with set current time.
Timer and lighting mode settings:
Step 1:
Light on setting
I.
Press once,
o
o
:
oo
will appear on the screen. Then press / to adjust the light-on hour.(e.g. if you set the Light-on at 6:00 , it
shows
o
o
:
o6
on the screen.)
II.
If no other setting is done afterwards, then after 8 seconds the hour will be saved or press to continue other setting. Or press to return to
the automatic running state.
Step 2:
Dawn time setting
I.
To set the
Dawn time
settings, press twice,
1
o
oo
will appear on the screen. Then press / to
adjust
the dawn time hour
. (e.g. if you set the dawn mode to run for 1 hour, it shows
1
o
o1
on the screen.)
II.
Next press to choose white (
1A
), or blue (
1
) and adjustthe brightness of each one by / . Combine them
to simulate the dawn effect.
III.
If no other setting is done afterwards, then after 8 seconds the dawn time setting will be saved or press to continue to other setting.
1
2
4
3
Up
Time settings
Lighting settings
Down
GB
In the lighting mode, the first digit is which time period
you are setting;
“
1
” indicates Dawn period
“
2
” indicates Sunrise period
“
3
”indicates Daytime period,
“
4
” indicates Sunset period
“
5
” indicates Nighttime period.
• The second digit shows which LED colours you are setting, “
A
”
is white LEDs, “ ” is blue LEDs.
• The last two digits indicate brightness levels from “
oo
” to “
3o
”.
• Show “
OFF
” mode
indicates Dawn period
