18
BA
05/2019
Before using the appliance for the first
time, read and comply with these safety
warnings. Keep these safety warnings
for consultation in the future or to hand
them over to successive owners.
• Before commissioning, read the appliance's
user manual.
• The warning plates on the appliance provide
important instructions for its safe use.
• Always comply with both the directions on
the instructions, as well as current safety
standards.
•
Keep the packing film out of the reach of
children. Risk of asphyxiation!
DANGER:
Indicates an imminent danger
that could cause serious injury or death.
WARNING:
Indicates a probable dangerous
situation that could cause serious injury or
death.
CAUTION:
Indicates a probable dangerous
situation that could cause minor injuries.
ATTENTION:
Indicates a probable
dangerous situation that could damage
objects.
SAFETY WARNINGS FOR DRY VACUUM
CLEANER
DANGER LEVELS
DANGER:
•
To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions
and warning indications before using. This vacuum cleaner has been designed to be safe when it
is used for cleaning in the specified manner. If damage to electrical or mechanical components is
found, the vacuum cleaner and/or the accessory must be repaired at the relative authorised service
centre or else at the manufacturer before use, in order to prevent further damage to the appliance
or physical injury to the user.
• Before connecting the appliance to the electricity socket, make sure the electrical information on
the plate corresponds to that of the mains supply.
The appliance must only be powered with
alternating current and voltage equal to that shown on the serial number plate
.
• The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
• Before using, check for any damage on the connection cable and on the power plug. If the cable is
damaged, immediately contact a specialist technician for restoring normal operations.
• Connect the appliance only to an electrical connection installed by an electrical installer in
conformity with IEC 60364-1.
• Never touch the power plug with wet hands.
•
Make sure that the cable to the mains or the extension cable have not been damaged by having
been walked on, crushed, pulled or the like. Protect the cable from heat and from contact with oils
or sharp edges.
• Regularly check that the cable connecting to the mains is not damaged, for example with signs of
ageing or cracks. If there is damage, the cable must be replaced by a specialist TMB srl technician
or else by a technician with similar qualifications before using the appliance again.
• Protection against splashes of water and the mechanical strength need to be ensured also after
any replacement of the joints of the power cable or the extension cable.
• Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or other
electrical faults).
CONNECTION TO THE ELECTRICITY GRID
