16
MAINTENANCE AND CLEANING TOOL
WARNING!
Remove the
cartridge strip from
the tool first.
1.
All parts should be cleaned with oil
detergent
and
wire
brushes
supplied with the tool kit.
2.
Remove heavy dirt build-up with
the brush.
3.
After cleaning with detergent oil,
all
parts
should
be
wiped
thoroughly dry.
4.
Excess oil will tend to accumulate
dirt and dust. Use eye protection
when cleaning the tool. Excess dirt
or dust on the piston and cylinder
assembly of the receiver must be
cleaned daily.
Please review the condition of the
piston
to
check
for
damage
or
deformation. For the tool to perform in
good operating condition and work well,
it is necessary to disassemble and clean
the tool when the dirt collects on the
side chamber or the tools seems to be
losing power. If the tool seems to be
losing power check for collected dirt in
the chamber, this may cause loss of
power. All parts must be cleaned as
above with oil and brushes. Be sure to
dry all parts when assembling your tool.
Depending
on
tool
use,
general
maintenance has to be done every six
months.
Use Eye Protection
TOOL DISASSEMBLY
WARNING!
Remove the
cartridge strip from
the tool first.
Use Eye Protection
1.
Remove the Spall Guard by gently
pulling it.
2. Unscrew the Guide Nut from the
Housing
Assembly
and
pull
the
Nosepiece.
Please watch the videos on our website:
http://bpfasteners.com/licensing/video
BLUEPOINT BP-27C - Disassembly:
BLUEPOINT BP-27C - Assembly:
17
NOTE: THE TOOL SHOULD BE CLEANED ONCE A WEEK
4.
From the other end, unscrew the
Pole Connector from Firing Pin
Housing, remove Connecting Tube
and Firing Pin Spring.
3.
Remove the Piston, Barrel and
Barrel Spring.
5.
Press the Braking Pin and push in
the Firing Pin Assembly inside the
Firing Pin Housing. Remove it from
the other end. (You may use the
Piston to push it). Remove Firing Pin
Assembly Spring,
Press Breaking Pin
Summary of Contents for BP-27C
Page 12: ...23 NOTES 22 NOTES ...