CONTENTS
ITEM
PAGE
1.
1
2. SPECIFICATION
6
3. GENERAL OPERATION MANUAL
8
4.
16
MAINTENANCE ..........................................
SAFETY ....................................................
........................................
............
5. EXPLODED DRAWING AND PARTS LIST ... 20
IMPORTANT INFORMATION: MUSTREAD
BEFORE YOU START
Read and understand tool labels
and all of operating instructions,
safety precautions and warnings in
this manual before operating or
maintaining this nailer.
Failure to follow warnings could result in DEATH
or SERIOUS INJURY.
Most accidents that result from the operation and
maintenance of Nailers are caused by the failure
to observe basic safety rules or precautions. An
accident can often be avoided by recognizing a
potentially hazardous situation before it
occurs, and by observing appropriate safety
procedures.
Basic safety precautions are outlined in the
“SAFETY” section of this Manual
Hazards that must be avoided to prevent bodily
injury or machine damage are identified by
DANGERS and WARNINGS on the Nailer and in
this Manual
Never use this Nailer for applications other than
those specified in this Manual.
EXPLANATION OF TERMINOLOGY
DANGER
indicates an imminent hazardous situation
which, if not avoided, will result in death
or serious injury.
WARNING
i ndic at es a pot enti al ly hazardous
situation which, if not avoided, could
result in death or serious injury.
CAUTION
i ndic at es a pot enti al ly hazardous
situation which, if not avoided, may
result in minor or moderate injury, or
may cause machine damage.
NOTE
emphasizes essential information.
EXPLANATION OF THE FUNCTION OF THE
GT-100L NAILER
This tool has a FULL SEQUENTIAL ACTUATION
MECHANISM. Fully depress the tool against the work
surface and actuate the trigger. Follow the same
sequence to continue driving nails after the push lever
and trigger are return back in place.
SAFETY
IMPORTANT SAFETY INSTRUCTIONS FOR
USING NAILERS
READ ALL INSTRUCTIONS
This Nailer is powered by internal
combustion device.
This Nailer shall only be used with
dispensers for combustible gas
which are listed in this manual.
DANGER
1. OPERATORS AND OTHERS IN WORK AREA
MUST WEAR SAFETY GLASSES WITH SIDE
SHIELDS.
When operating the Nailer, always
w ear safety glass es with side
shields, and make sure others in
work area wear safety glasses.
Safety glasses must conform to the requirements
of American National Standards Institute,
ANSI Z87.1 and provide protection against flying
particles both from the front and side.
Th e e mp lo ye r mu st e n f o rce t h e u se of
safety glass es by the Nail er operator and
others in work area.
2. NEVER USE IN PRESENCE OF FLAMMABLE
LIQUIDS OR GASES.
This Nailer must not be used in a
c o m b u s t i b l e e n vironment or in
presence of flammable liquids or
gases, e.g. lacquer, paint, benzine,
thinner or gasoline.
This Nailer produces hot exhaust gases that
may ignite flammable materials and also
produces sparks during operation.
3. DO NOT TOUCH AROUND THE EXHAUST
OUTLET.
This Nailer produces hot exhaust
gases that may ignite flammable
materials. The firing hea d an d
n os e w il l become hot and get
heated up after prolonged or rapid
use. Do not touch with bare hands.
4. EXPLOSION AND FIRE HAZARD.
The fuel cell is an aerosoldispensers
with flammable contents.
Pressured container and the
propellant will remain in the fuel cell.
Faillure to follow instructions may
result in explosion or fire.
1
