BlueSecure™ Access Point 1840 Installation Guide
16
General Specifications
for a description of the IEC/EN60601-1 compliant power adapter.
4.
Verify that the PWR LED stops flashing and remains on, and that the other status LEDs start
functioning as described in the section entitled
4.
4.
LED Indicators
.
5.
Connect the BSAP to your Bluesocket WLAN.
You can connect the BSAP-1840 to a 10/100/1000 Mbps Ethernet through a network device
such as a hub or a switch, or to a 1000BaseT Gigabit Ethernet interface. Connect the RJ-45
Ethernet connector on the BSAP’s back panel to your network using category 5 UTP
Ethernet cable. When the BSAP and the connected device are powered on, the BSAP’s
Ethernet Link LED should light indicating a valid network connection.
