BlueSecure™ Access Point 1840 Installation Guide
19
•
•
Using the BSAP’s Site Survey Mode
for details on using the BSAP’s site survey mode.
When operating in a submenu, press h to return directly to the main menu (or home menu).
Press p to return to the previous menu.
BSAP Default Configuration
The BSAP is shipped with the following default configuration.
IP_ADDR_MODE:
DHCP (0)
IP_ADDR 0.0.0.0
NETMASK 0.0.0.0
GW_ADDR
0.0.0.0
DNS_ADDR
0.0.0.0
WG_ADDR_MODE
Discover BSC (0)
WG_ADDR
0.0.0.0
MNGMT_IP_ADDR 192.168.190.1
The two options for IP address mode are:
•
(0) DHCP - The BSAP runs a DHCP client and receives its IP address from a DHCP
server.
•
(1) Static IP - You assign the BSAP a static IP address via its CLI.
The two options for WG address mode are:
•
(0) Discover - The BSAP automatically discovers the IP address of the BSC to which it
is to connect.
•
(1) Static Configuration - Using the BSAP CLI, you will configure the IP address of
the BSC to which the BSAP is to connect.
Setting the BSAP and Home BSC IP Addresses Using the CLI
To set the BSAP and Home BSC IP addresses using the CLI:
1.
Enter 1 at the BSAP CLI main menu command prompt.
The BSAP CLI network configuration menu appears:
