Please make sure that you read these instructions carefully in order to avoid injury when using
the tool. Follow all health and safety rules and regulations. If in doubt and available please
contact a more knowledgeable source.
DO NOT
use if damaged.
WARNING:
ALWAYS use safety goggles and the correct PPE when using the glue gun.
WARNING:
ALWAYS work in a well ventilated area when using the glue gun.
WARNING:
DO NOT touch the nozzle or molten adhesive as they will be extremely hot during and
for some time after use.
WARNING:
Noxious and irritating fumes may be released - from heating glue stick. Molten
material may cause burns.
WARNING:
DO NOT use the glue gun in damp or wet conditions.
WARNING:
DO NOT expose to rain.
• If tool is damaged do not use as this may cause damage to property or injury.
• Maintain tool in good and clean condition for best and safest performance.
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear
non-slip shoes.
• Keep children and unauthorised persons away from the work area.
• In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• Ensure the Glue Stick (2) is inserted correctly into the glue gun before connecting to the
mains power supply.
• Never leave a glue gun unattended. Always make sure the glue gun is disconnected from the
power supply.
• The hot nozzle must never come into contact with flammable materials.
02
Product Introduction
The BlueSpot 40W Glue Gun is ideal for general use. Hot melt glue dries in approximately 60
seconds depending on the quantity of glue you have applied. Bonds to paper, plastic, wood,
ceramics and some metals. Includes two hot melt glue sticks. This product is double insulated.
Specifications
Input voltage: 50Hz
Max power: 40W
Constant temperature power: 12W
Pre-heating time: 3 - 5min
1. Nozzle
2. Glue Stick
3. Handle
4. Power Cord
5. Trigger
6. Mounting Points For Stand
7. Stand
8. Second Glue Stick
1
2
3
4
5
6
7
8
• Always practice applying adhesive to scrap materials until confident.
• The glue gun is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, remove from use immediately.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If you are in doubt please contact
a qualified electrician.
Safe use
(continued)
