- 14 -
GAS CONVERSION
WARNING:
IN ORDER TO AVOID A FIRE OR EXPLOSION, CAUSING PROPERTY DAMAGE, PERSONAL
INJURY OR DEATH; PRECAUTION MUST BE TAKEN WHEN PERFORMING A CONVERSION BY ENSURING
THAT THE VALUES IN THE GAS PRESSURE CHARTS ARE EMPLOYED WHERE APPLICABLE.
Any field gas conversions will automatically void the manufacturers warranty!!
Gas conversions should only be performed by
a licensed plumber or licensed gas fitter in the Commonwealth of Massachusetts to assure a complete and
safe conversion. Please contact your distributor for additional information regarding gas conversion.
ELECTRICAL CONNECTION
There is no connection necessary beyond plugging the unit into a polarized, grounded, 120-volt, 60-Hz, 15-amp circuit.
This circuit,
however, MUST be grounded and properly polarized.
The unit is equipped with a NEMA #5-15P power cord, accessed by removing the rear panel, and if an extension is required, it must be
at least this gauge.
NOTE:
If electrical power is not supplied or is interrupted, the unit will not be operational.
WARNING ! ! !
This appliance is equipped with a three-pronged grounded plug for your protection against shock hazard and should be
plugged directly into a properly grounded receptacle.
Do not cut or remove the grounding prong from this plug.
If the unit is not grounded or its polarity is reversed, severe shock hazards can exist.
**Removing the third prong will void the manufacturers warranty**
INSTALLERS & END-USERS INITIAL CHECK
All units are adjusted and tested before leaving the factory. The manufacturer has supplied you with an installers point checklist in order for
your technician to properly install your new unit.
Requirements for your unit must be installed to factory specifications. Failure to perform the installation checklist and returning it will void
the warranty coverage agreement. When this range is properly installed and connected to proper gas and electrical service, it will operate
properly. Any issues regarding service should be directed to your distributor or the factory at (610) 376-7826.
