- 29 -
DOOR PANEL REMOVAL INSTRUCTIONS
1. Remove the (2) screws located above the kick panel.
2. Loosen the (2) screws located below the kick panel on each side.
3. Remove kick panel by lifting gently and pulling away.
4. After kick panel is removed, remove the (5) screws located on the bottom flange of the door.
5. With the screws removed pull door panel away from the bottom of the door while lifting the door off the door liner.
6. Upon reinstallation of panel assembly assure that all dirt or fingerprints are removed from window glass.
COMPLETE DOOR REMOVAL INSTRUCTIONS
1. Open the oven door completely.
2. At the top of each hinge, immediately next to the frame there is a clip that rotates out. The clip is easy to open using a
screwdriver. Place the tip of the screwdriver in the square opening and rotate out.
3. Pull the door up as if to close the door (please note the hinge position in the receiver at this time for step 6). Lift straight up and
out by the oven door handle. Please be sure to use both hands at either end of the handle for this step.
4. Replace the oven door by sliding the hinges into the receiver, making sure that the notch in the hinges is resting properly. This
would be the same position noted in step 2.
5. Rotate the clips down to secure.
6. Check to assure the door assembly is straight or parallel with the range body sides, and closes smoothly.
