- 6 -
INSTALLATION
REQUIREMENTS
1. This unit has been designed to be installed directly against rear walls and side base cabinets. It
cannot,
however, be installed
directly against
tall
side cabinets, sidewalls, tall appliances, or base cabinets extending beyond 24”. (see, 'Proximity to Side
Cabinets').
2. The side trims must be at least 11/16" above adjoining counter top surfaces (see 'Proximity to Side Cabinets').
3. Any openings in the back wall or floor of the installation site must be sealed.
4. Electrical requirements: 120 volt, 15 amp, 60Hz properly grounded household current. The receptacle must be positioned to
prevent strain and physical damage to the power supply cord.
5. Gas requirements: Natural Gas...5.0" WC; LP Gas 10.0" WC.
6. Proper ventilation must be installed for this product. For best results, consult with your dealer or HVC installer for minimum
CFM’s.
7.
The installation of this appliance must conform with local codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1.
In Canada, installation must be in accordance with the current CAN/CGA B149.1 and .2 installation codes and/or local
codes.
NOTE:
Be sure to check the rating plate label located on the left side under the burner grate to confirm that the appliance is properly equipped for the
gas supply.
WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS:
This unit must be electrically grounded in accordance with local codes, and the National Electrical Code ANSI/NFPA No.
70, (or latest edition). A licensed electrician must make installation. This appliance is equipped with a three-prong
grounding plug for your protection against shock hazard, and should be plugged directly into a properly grounded
receptacle.
Do not cut or remove the grounding prong from this plug.
In Canada, the installation must be in accordance with the current
CSA C22.1 Canadian Electrical Code, Part 1, and local codes.
**IMPROPER INSTALLATION WILL VOID WARRANTY**
