Chapter 3 BV-3100 Installation
After verifying that all necessary components are present, you are ready to begin
integration of the BV-3100.
Assembling the Pole
The following instructions will walk you through all steps necessary to assemble the
pole, mount the sonar, and connect all required cabling.
1. Remove the pole unit from shipping case.
2. Place the top and bottom pole pieces end to end and pull the excess cable
through the top of the pole.
3. Rotate one of the pole segments till the alignment notches are adjacent to
each other.
4.
Attach the lower section to the upper using the provided cap screws. Insert
the bolt first through the unthreaded upper flange and screw into the
threaded lower flange.
BV-3100 User’s Handbook
15 April 2009
Page
7