FN-SV3014
SIDE EMITTING SERIES(SINGLE ROW LED)
Clips
Electric iron
Diagonal pliers
Electric drill
2.Installation Methods and Steps
By self adhesive tape
Install with clips
Peel away the self
adhesive tape on the
rear.
Clean the mounting
surface
Peel away the self
adhesive tape on the
rear.
Evenly arrange the
strips with appropriate
space in the light box.
Stick the strips on the
signage accordingly
Connect the strips
with compatible power
supply
Cut off the excess
part based on the
installation position.
Connect main line to
power supply.
Evenly arrange the
strips with appropriate
space in the light box
Use soldering iron
for welding if need
connection.
Attentions
Before installation, check that the product parameters are consistent with the requirements (Seeing product specifications or product labels)
Load voltage, current, power and power supply should be matched with the product.
Follow the instructions of wiring diagram (first connect the load and then the power supply) to avoid short circuit.
Make sure the correct connection of positive and negative poles between led module and power supply. Otherwise, the light will not be on.
Make sure the power cord firmly screwed into the terminal and it should not be pulled out by hands.
The terminal should have insulation,waterproof and anti-corrosive treatment
Take care of being cut by sharp edges.
If the working length exceeded the max run length, make sure to have extra power supply.
If it needs higher current of a LED, make sure having extra cooling.
