System Installation of Evaluation Kit
9
1.4
IO Introduction
(1)
IO
A.
P00 to P29 are digital IO, available for GPIO.
B.
P30 to P35 are analog input, not available for GPIO.
C.
P00 and P01 are linked to SWCLK and SWDIP of J-Linkrespectively.
(2)
UART
A.
P12 and P13 are TX and RX of UARTO respectively.
(3)
SPI
A.
Supports SPI 2 channels at the most, and pins of SPIM and SPIS are fixed when processing.
B.
SPIM0 uses P02(CS1), P03(CS0), P04(CLK), P05(MISO), and P06(MOSI).
C.
SPIM1 uses P07(CS1), P08(CS0), P09(CLK), P10(MISO), and P11(MOSI).
D.
SPIS uses P03(CS), P04(CLK), P05(MISO), and P06(MOSI).
(4)
I²C
A.
Equipped with I²C 2 channels, configuration available from P02 to P23.
(5)
PWM
A.
Supports PWM 5 channels at the most, configuration available from P02 to P23.
(6)
ADC
A.
Supports 6 channels of ADC data acquisition at the most. Independant analog IO of each(P30
to P35).
(7)
External Interrupt
A.
P15, P16, P17, P22, and P23 are external interrupt pins to support wake-up from sleep
mode.
Summary of Contents for BX2400-dRF0xp-S1c
Page 15: ...System Installation of Evaluation Kit 15 5 Wait for installing 6 Click Finish to complete ...
Page 27: ...System Installation of Evaluation Kit 27 G RTT Log as below ...
Page 29: ...29 6 Appendix 6 1 Schematic of BX2400 dRF0xp S1c ...
